Specifications
DOCSIS 1.1 for Cisco uBR905 and Cisco uBR925 Cable Access Routers and Cisco CVA122 Cable Voice Adapters
Command Reference
98
Cisco IOS Release 12.2(15)CZ
valid 13-bit bitmask showing which Type/Length/Value (TLV) fields were set on
the classifier. The following shows the meaning of each bit, with the least
significant bit on the far right. The bit is set to 1 if the corresponding TLV
was set for the classifier:
• 0x0001—IP Type of Service Range and Mask
• 0x0002—IP Protocol
• 0x0004—IP Source Address
• 0x0008—IP Source Mask
• 0x0010—IP Destination Address
• 0x0020—IP Destination Mask
• 0x0040—TCP/UDP Source Port Start and TCP/UDP Source Port End
• 0x0080—TCP/UDP Destination Port Start and TCP/UDP Destination
Port End
• 0x0100—Destination MAC Address
• 0x0200—Source MAC Address
• 0x0400—Ethertype/DSAP/MacType
• 0x0800—IEEE 802.1P User_Priority
• 0x1000—IEEE 802.1Q VLAN_ID
For example, a value of D6 translates to the bit-mask “1101 0110”, which
indicates that the following fields were set for the classifier: IP Protocol,
IP Source Address, IP Destination Address, and the TCP/UDP Source and
Destination Port values.
Match Number of packets matching the classifier.
SIDT Address for the classifier in the internal SID table (SIDT).
Packet Classifier Details Detailed description of each packet classifier.
Classifier ID ID used to uniquely identify the classifier in each service flow.
SFID ID that uniquely identifies the service flow.
IP source Matching IP source address.
IP dest Matching IP destination address.
UDP/TCP source range Low-end and high-end matching source TCP/UDP port values.
UDP/TCP dest range Low-end and high-end matching destination TCP/UDP port values.
IP Protocol Matching IP protocol type, as given in RFC 1700. A value of 256 matches
any IP protocol, and a value of 257 matches TCP and UDP traffic.
PHS Whether payload header suppression (PHS) is active or inactive.
Downstream Payload
Header Suppression
Whether PHS is being used on the downstream.
Table 12 show controllers cable-modem qos Field Descriptions (DOCSIS 1.1) (continued)
Field Description