Specifications

DOCSIS 1.1 for Cisco uBR905 and Cisco uBR925 Cable Access Routers and Cisco CVA122 Cable Voice Adapters
Command Reference
100
Cisco IOS Release 12.2(15)CZ
show controllers cable-modem service-flows
To display the service flows that are configured on the router, use the show controllers cable-modem
service-flows command in privileged EXEC mode.
Cisco uBR905, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
show controllers cable-modem number service-flows [sfid | summary]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines This command displays the Quality of Service (QoS) parameters that make up each of the service flows
that are defined on the router for the upstream and downstream. The information shown corresponds to
the QoS parameters that are listed in Appendix C of the DOCSIS 1.1 specification.
Examples The following example shows typical output for the default form of the show controllers cable-modem
service-flows command.
Router# show controllers cable-modem 0 service-flows
Upstream Flow Scheduler Parameters
Flow Type: Primary
Flow Reference: 1
Service Flow ID: 3
Service ID: 2
QoS Set Type: 7
QoS Traffic Priority: 0
QoS Max Sustained Traffic Rate: 0
QoS Max Traffic Burst: 1522
QoS Min Reserved Traffic Rate: 0
QoS Min Reserved Rate Pkt Size: 0
QoS Timeout For Active Param: 0
Qos Timeout For Admitted Param: 200
Max Concatenated Burst: 0
Scheduling Type: 0x2
Request/Transmission Policy: 0x0
Nominal Polling Interval: 0
Tolerated Poll Jitter: 0
number Identifies the cable interface (always 0).
sfid (Optional) Displays detailed information for a specific service flow, as
identified by its service flow ID (SFID). The valid range for sfid is 1 to
2147483647.
summary (Optional) Displays a summary report of all service flows.
Release Modification
12.2(15)CZ This command was introduced for the Cisco uBR905 and Cisco uBR924
cable access routers, and the Cisco CVA122 Cable Voice Adapter.