Installation guide

2-25
Cisco uBR7100 Series Universal Broadband Router Software Configuration Guide
OL-2238-03
Chapter 2 Configuring the Cisco CMTS for the First Time
Where to Go Next
Router# show controllers cable slot/port upstream
To check the value of the settings you entered, enter the show running-config command at the Router#
prompt:
Router# show running-config
To review changes you make to the configuration, use the EXEC show startup-config command to
display the information stored in NVRAM.
Where to Go Next
After you have minimally configured the Cisco uBR7100 series CMTS, refer to Chapter 3, “Configuring
the Cisco Cable Interface” for more advanced configuration instructions. Also refer to Chapter 5,
“Troubleshooting the System” for information on troubleshooting your initial configuration.
The Cisco IOS software running the Cisco uBR7100 series CMTS contains extensive features and
functionality. The effective use of these features is easier if you have more information at hand. For
additional documentation about configuring the Cisco uBR7100 series CMTS and system capabilities,
refer to resources cited in the “Preface”. For instructions on configuration of port adapters, refer to the
respective installation document that shipped with the port adapter.