Installation guide

2-23
Cisco uBR7100 Series Universal Broadband Router Software Configuration Guide
OL-2238-03
Chapter 2 Configuring the Cisco CMTS for the First Time
Using the Setup Facility for Cable Interfaces
0 input packets with dribble condition detected
0 packets put, 284529 bytes, 0 underruns
0 output errors, 0 collisions, 10 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Note The interface type in the show interfaces command must match the actual interface type of the port
adapter. For example, if you enter sh int e 1/0 and a HSSI port adapter is actually in port adapter slot
1/0, the command returns an “invalid input” error.
Tip At any time you can enter a question mark (?) for help. Use ctrl-c to abort the configuration dialog at
any prompt. The default settings are enclosed in brackets '[]'.
Would you like to enter basic management setup? [yes/no]: no
First, would you like to see the current interface summary? [yes]:
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 10.20.133.2 YES NVRAM up
up
FastEthernet1/0 1.11.1.1 YES NVRAM up up
Cable1/0 10.20.133.65 YES NVRAM up up
Configuring Global Parameters
Step 1 Type this command: Enter host name [ishita-cmts]:
Next, the enable secret is a password used to protect access to privileged EXEC and configuration
modes. This password, after entered, becomes encrypted in the configuration.
Step 2 Type this command: Enter enable secret [Use current secret]: aa
Next, the enable password is used when you do not specify an enable secret password, with some older
software versions, and some boot images.
Step 3 Type this command: Enter enable password [rHoz]: bb
Next, the virtual terminal password is used to protect access to the router over a network interface.
Step 4 Type this command: Enter virtual terminal password [cc]:cc
The following system information displays.
Configure SNMP Network Management? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]:
Configure CLNS? [no]:
Configuring interface parameters:
Do you want to configure FastEthernet0/0 interface? [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [yes]: no
Do you want to configure Ethernet1/0 interface? [yes]: n
Do you want to configure Cable1/0 interface? [yes]:
Downstream setting frequency : 531000000
For cable upstream [0]
Shut down this upstream ? [yes/no]: no
Frequency : 33808000