Specifications

Command Reference
20
Cisco IOS Release 12.0(3)T
cable-modem compliant bridge
To enable DOCSIS-compliant transparent bridging for a cable modem interface at startup, use the
cable-modem compliant command from interface configuration mode. Use the no form of this
command to disable DOCSIS-compliant bridging for the interface.
cable-modem compliant bridge
no cable-modem compliant bridge
Syntax Description
This command has no arguments or keywords.
Default
Enabled
Command Mode
Interface configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3 NA.
It is normally not necessary to enter this command in data-over-cable bridging applications because
DOCSIS-compliant bridging is enabled by default. If you wish to do full transparent bridging rather
than DOCSIS-compliant bridging, use the no form of the command, then configure full transparent
bridging using CLI commands. See the “Configuring Bridging” section on page 13 for instructions.
Example
The following example shows how to enter the cable-modem compliant bridge command for a
cable modem interface, starting from global configuration mode:
uBR904(config)# interface cable-modem 0
uBR904(config-if)# cable-modem compliant bridge
uBR904(config-if)#
Related Commands
cable-modem downstream saved channel
cable-modem fast-search
cable-modem upstream preamble qpsk
interface cable-modem