Specifications

Cable Installation and Interface Configuration 8-15
Checking the Configuration
Following is an example of how the show interfaces [port-adapter/port] command displays status
information for the interfaces you specify. In this example, the PA-H is in port adapter slot 0 on the
Catalyst RSM/VIP2. (Interfaces are administratively shut down until you enable them.)
Router# show interfaces hssi 0/0
Hssi0/0 is up, line protocol is up
Hardware is HSSI-B
Internet address is 10.10.10.1/24
MTU 4470 bytes, BW 45045 Kbit, DLY 200 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
Last input 2d22h, output 00:00:19, output hang never
Last clearing of “show interface” counters 2d20h
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
4084 packets output, 1298712 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Use the show version command to display the configuration of the system hardware (the number of
each interface processor type installed), the software version, the names and sources of configuration
files, and the boot images.
Following is an example of the show version command:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (C5RSM-JV-MZ), Version 11.1(12)CA1
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Fri 06-Oct-95 12:22 by mpo
Image text-base: 0x600088A0, data-base: 0x605A4000
ROM: System Bootstrap, Version 5.3(5)
ROM: GS Bootstrap Software (RSP-BOOT-M), Version 11.1(12), RELEASED SOFTWARE
Router uptime is 4 hours, 22 minutes
System restarted by reload
System image file is “slot0:c5rsm-jv-mz”, booted via slot0
cisco RSP7000 (R4600) processor with 16384K bytes of memory.
R4600 processor, Implementation 32, Revision 2.0
Last reset from power-on
G.703/E1 software, Version 1.0.
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Chassis Interface.
1 VIP2 controllers (2 HSSI).
2 HSSI network interfaces.
125K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2