Specifications

Cisco uBR7200 Series and the PA-H HSSI Port Adapter 6-5
Installing a Port Adapter
Figure 6-6 Placing the Port Adapter Retention Clip in the Locked
Position
—Cisco uBR7246
For a Cisco uBR7223, place the port adapter lever in the locked position. (See
Figure 6-7.)
Figure 6-7 Placing the Port Adapter Lever in the Locked Position—Cisco uBR7223
Note If the port adapter lever does not move to the locked position, the port adapter is
not completely seated in the midplane. Carefully pull the port adapter halfway out of the
slot, reinsert it, and move the port adapter lever to the locked position.
This completes the procedure for installing a new port adapter or replacing a port adapter in a
Cisco uBR7200 series universal broadband router. To install the necessary cables and configure your
PA-H, proceed to “Chapter 8, “Cable Installation and Interface Configuration.”
H11517
Port adapter
retention clip in
locked position
Port adapters
16177
Port adapter
lever in locked
position
Port adapters