Specifications

Installing a Port Adapter
PA-H HSSI Port Adapter Installation and Configuration5-4
Figure 5-4 Aligning the Port Adapter Metal Carrier Between the Slot Guides—Cisco 7206
Step 4 With the metal carrier aligned in the slot guides, gently slide the port adapter halfway into
the slot.
Caution Do not slide the port adapter all the way into the slot until you have connected all required
cables. Trying to do so will disrupt normal operation of the router.
Step 5 With the port adapter halfway in the slot, connect all required cables to the port adapter.
Step 6 After connecting the cables, carefully slide the port adapter all the way into the slot until
you feel the port adapter’s connectors seat in the midplane.
Step 7 Move the port adapter lever to the locked position. Figure 5-5 shows the lever in the
locked position.
Note If the lever does not move to the locked position, the port adapter is not completely
seated in the midplane. Carefully pull the port adapter halfway out of the slot, reinsert it,
and move the port adapter lever to the locked position.
H6597
MII
EN
RJ45
EN
RJ45
LINK
1O PWR
OK
RJ-45
CPU RESET
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII
2
4
6
1
3
5
ETHERNET 10BT
ENABLED
0
2
1
3
LINK
0
1
2
3
ENABLED
MII
LINK
RJ45
FAST ETHERNET
0
TOKEN RING
0
1
2
3
Slot
guide
Note: This adapter alignment
applies to any port or service
adapter.