Specifications
Removing a Port Adapter
PA-H HSSI Port Adapter Installation and Configuration5-2
Depending on your circumstances, you might need to install a new port adapter in a Cisco 7200
series router or replace a failed port adapter in the field. In either case, no tools are necessary; all port
adapters available for the Cisco 7200 series connect directly to the router midplane and are locked
into position by a port adapter lever. When removing and replacing a port adapter, you will need an
antistatic mat onto which you can place a removed port adapter and an antistatic container into which
you can place a failed port adapter for shipment back to the factory.
Note The Cisco 7200 series routers support online insertion and removal (OIR); therefore, you do
not have to power down the Cisco 7200 series routers when removing and replacing a HSSI port
adapter.
When a port adapter slot is not in use, a blank port adapter must fill the empty slot to allow the router
to conform to EMI emissions requirements and to allow proper air flow across the port adapters. If
you plan to install a new port adapter in a slot that is not in use, you must first remove a blank port
adapter.
Removing a Port Adapter
Use the following procedure to remove a port adapter from a Cisco 7200 series router:
Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
Step 2 Place the port adapter lever for the desired port adapter slot in the unlocked position. The
lever remains in the unlocked position. (See Figure 5-2.)
Figure 5-2 Placing the Port Adapter Lever in the Unlocked Position—Cisco 7206
Step 3
Grasp the handle on the port adapter and pull the port adapter from the midplane, about
halfway out of its slot. If you are removing a blank port adapter, pull the blank port
adapter completely out of the port adapter slot.
ETHERNET 10BT
ENABLED
0
2
1
3
LINK
0
1
2
3
FAST SERIAL
EN
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
ENABLED
MII
LINK
RJ45
FAST ETHERNET
0
TOKEN RING
0
1
2
3
0
2
4
1
3
5
6
H6596
MII
EN
RJ45
EN
RJ45
LINK
1O PWR
OK
RJ-45
CPU RESET
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII
Port adapter
handle
Port adapter
lever (unlocked
position)
Note: This adapter removal
applies to any port or service
adapter.