Specifications

Installation Overview
PA-H HSSI Port Adapter Installation and Configuration
4-6
Figure 4-5 Port Adapter Installed in a Port Adapter Slot—Partial Port Adapter View
Step 11
Replace the screw in the rear of the port adapter slot. (See Figure 4-2 for its location.) Do
not overtighten this screw.
Step 12 Reinstall the Catalyst RSM/VIP2 in the system. Follow the steps in the Route Switch
Module Catalyst VIP2-15 and VIP2-40 Installation and Configuration Note (Document
Number 78-4780-01) which shipped with your Catalyst RSM/VIP2.
Step 13 If disconnected, reconnect the interface cables to the port adapters.
This completes the procedure for installing a new port adapter or replacing a port adapter on a
Catalyst RSM/VIP2. To install the necessary cables and configure your PA-H, proceed to Chapter 8,
“Cable Installation and Interface Configuration.”
H3152