Specifications

Installation Overview
PA-H HSSI Port Adapter Installation and Configuration
4-2
Figure 4-1 Catalyst RSM/VIP2-40 with One PA-H in Port Adapter Slot 0
Note Port adapters have a handle attached, but this handle is not shown to allow a full view of detail
on each port adapter’s faceplate.
Depending on the circumstances, you might need to install a new port adapter on a
Catalyst RSM/VIP2 motherboard or replace a failed port adapter in the field. In either case, you will
need the following items:
• Number 1 Phillips screwdriver
• Antistatic mat onto which you can place the removed interface processor
• Antistatic container into which you can place a failed port adapter for shipment back to the
factory
Caution To prevent system problems, do not remove port adapters from the Catalyst RSM/VIP2
motherboard, or attempt to install other port adapters on the Catalyst RSM/VIP2 motherboard while
the system is operating. To install or replace port adapters, first remove the Catalyst RSM/VIP2 from
its interface processor slot.
26799
Port adapter
blank in slot 1
Port adapter handles not shown
Front mounting hole
(hidden from view)
Front mounting hole
(hidden from view)
Backplane
bus connector
Ribbon cables
ENABLED
HSSI
Rev. B
TD TC RD RC LB/C
0
1
Standoff
mounting
holes
Standoff
mounting
holes
Standoff
mounting
hole
Port adapter
securing screw
Port adapter
securing screw
PA-H port adapter
in slot 0