Specifications

VIP2 and the PA-H HSSI Port Adapter 3-5
Installation Overview
Step 10 Carefully slide the new port adapter into the port adapter slot until the connector on the
port adapter is completely mated with the connector on the motherboard (see Figure 3-6).
Figure 3-6 Port Adapter Installed in a Port Adapter Slot—Partial Port Adapter View
Step 11
Replace the screw in the rear of the port adapter slot. (See Figure 3-3 for its location.) Do
not overtighten this screw.
Step 12 Reinstall the VIP2 in the system. (Follow the steps in the section “Installing a VIP2” in
the configuration note Second-Generation Versatile Interface Processor (VIP2)
Installation and Configuration that shipped with your VIP2.)
Step 13 If disconnected, reconnect the interface cables to the port adapters.
This completes the procedure for installing a new port adapter or replacing a port adapter on a VIP2.
To install the necessary cables and configure your PA-H, proceed to Chapter 8, “Cable Installation
and Interface Configuration.”
H3152