Manualshelf

Specifications

ManualsBrandsCisco ManualsComputer equipmentUBR7223 - uBR 7223 Modular Expansion Base
21222324252627282930
VIP2 and the PA-H HSSI Port Adapter 3-3
Installation Overview
When only one port adapter is installed on a VIP2, a blank port adapter must fill the empty slot to
allow the VIP2 and router chassis to conform to electromagnetic interference (EMI) emissions
requirements, and so that air flows through the chassis properly. If you plan to install a new port
adapter, you must first remove the blank port adapter.
Note The BABT605559 marking on the PA-H (see Figure 1-2) signifies that the port adapter meets
United Kingdom directive 605559 and has been designed to BABT/TC/130 standards.
Use the following standard procedure to remove and replace any type of port adapter on a VIP2:
Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
Note To install a new port adapter on a VIP2 with a single port adapter, you must first
remove the blank port adapter from the port adapter slot in which you want to install the
new port adapter.
Step 2 For a new port adapter installation or a port adapter replacement, disconnect any interface
cables from the ports on the front of the port adapter, although this is not required. You
can remove VIP2s with cables attached; however, we do not recommend it.
Step 3 Remove the VIP2 from the system. (Follow the steps in the section “Removing a VIP2”
in the configuration note Second-Generation Versatile Interface Processor (VIP2)
Installation and Configuration that shipped with your VIP2.)
Step 4 Place the removed VIP2 on an antistatic mat.
Step 5 Locate the screw at the rear of the port adapter (or blank port adapter) to be replaced. (See
Figure 3-3.) This screw secures the port adapter (or blank port adapter) to its slot.
Figure 3-3 Location of Port Adapter Screw—Partial Port Adapter View
Step 6
Remove the screw that secures the port adapter (or blank port adapter).
Step 7 With the screw removed, grasp the handle on the front of the port adapter (or blank port
adapter) and carefully pull it out of its slot, away from the edge connector at the rear of
the slot. (See Figure 3-4.)
H3148
Screw