Specifications

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
Removing and Replacing an AC PEM
21
AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
78-13996-01 Rev. B0
Figure 14 Setting AC Power Switch to the ON Position
Step 13 When you turn on the power switch on each AC PEM, its Fault LED should go off and the Power LED
should come on (green).
Step 14 Slide the front bezel cover onto the four corner posts of the chassis and then push down, so that the posts
are seated in the grooves above the cover holes. The AC power cables should be routed through the notch
on the right side of the cover.
62671
ALARMS
FAIL
PERFORMANCE ROUTING ENGINE
STATUS
ACO
CRITICAL
MINOR
MAJOR
ALARMS
FAIL
PERFORMANCE ROUTING ENGINE
STATUS
ACO
CRITICAL
MINOR
MAJOR
AC
SWITCH
ACINPUT
200-240V
13A 50/60Hz
AC
SWITCH
ACINPUT
200-240V
13A 50/60Hz
AC
SWITCH
ACINPUT
200-240V
13A 50/60Hz