Specifications

ManualsBrandsCisco ManualsComputer equipmentuBR10012 Universal Broadband Router UBR10-FAN-CAB=

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

Removing and Replacing an AC PEM

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

78-13996-01 Rev. B0

Figure 12 Installing the AC PEM

Step 8 Position the second replacement AC PEM in the power bay and push it forward. Verify that it goes all

the way in and makes a secure connection with the backplane. Tighten the captive screws to secure the

unit to the chassis (Figure 12).

Caution Although one AC PEM can supply sufficient power for a fully configured chassis, run the

Cisco uBR10012 router with two AC PEMs installed, because this provides redundant power

support.

Step 9 Plug the AC-input power cable into the power receptacle on the front panel of each AC PEM.

Step 10 Route the power cable up the front of the AC PEM and clip it into the two plastic retaining clips attached

to the surface of the PEM. Route the power cable out through the right side, so that it fits through the

notch on the right side of the front bezel cover. (Figure 13)

62524

POWER

FAULT

ALARMS

CISCO

10000

FAIL

PERFORMANCE ROUTING ENGINE

CONSOLE

STATUS

ACO

CRITICAL

MINOR

MAJOR

ETHERNET

LINK

ACTIVITY

AUX

SLOT 0

SLOT 1