Specifications

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
Removing and Replacing an AC PEM
17
AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
78-13996-01 Rev. B0
Figure 10 Turning the AC PEM Off
Step 3 Unplug the AC-input power cable from the power plug on the front panel of each AC PEM. For safety,
also unplug the other end of the power cable from each AC-input power source.
Tips For true redundant power protection, ensure that you are using a separate AC-input power source for
each AC PEM.
Step 4 Use the screwdriver to loosen the captive screws on each AC PEM. Then pull each AC PEM from the
chassis by using the handle on the faceplate (Figure 11 on page 18). Set the two AC PEMs aside.
77142
ALARMS
FAIL
PERFORMANCE ROUTING ENGINE
STATUS
ACO
CRITICAL
MINOR
MAJOR
ALARMS
FAIL
PERFORMANCE ROUTING ENGINE
STATUS
ACO
CRITICAL
MINOR
MAJOR
AC
SWITCH
ACINPUT
200-240V
13A 50/60Hz
AC
SWITCH
ACINPUT
200-240V
13A 50/60Hz
ACINPUT
200-240V
13A 50/60Hz
AC
SWITCH