Specifications

ManualsBrandsCisco ManualsComputer equipmentuBR10012 Universal Broadband Router UBR10-FAN-CAB=

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

Removing and Replacing an AC PEM

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

78-13996-01 Rev. B0

Figure 8 Routing the AC Power Cables

Step 10 Plug the other end of the AC-input power cable into a 200–240 VAC power outlet. For fully redundant

operation, each AC PEM should use separate power sources, or you should be using an uninterruptible

power supply (UPS).

The Fault LED on the AC PEM should be yellow to indicate that the AC PEM is receiving power from

the power source but is not yet supplying power to the Cisco uBR10012 chassis.

Step 11 Push up the power switch on the replacement AC PEM to the ON (|) position (Figure 9 on page 16).

ALARMS

CISCO

10000

FAIL

PERFORMANCE ROUTING ENGINE

CONSOLE

STATUS

ACO

CRITICAL

MINOR

MAJOR

ETHERNET

LINK

ACTIVITY

AUX

SLOT 0

SLOT 1