Specifications

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
Removing and Replacing an AC PEM
14
AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
78-13996-01 Rev. B0
Figure 7 Installing the AC PEM
Step 8 Plug the AC-input power cable into the power receptacle on the front panel of the AC PEM.
Step 9 Route the power cable up the front of the AC PEM and clip it into the two plastic retaining clips attached
to the surface of the PEM. Route the power cable out through the right side, so that it will fit through the
notch on the right side of the front bezel cover. (Figure 8)
62524
POWER
FAULT
ALARMS
CISCO
10000
FAIL
PERFORMANCE ROUTING ENGINE
CONSOLE
STATUS
ACO
CRITICAL
MINOR
MAJOR
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
ALARMS
CISCO
10000
FAIL
PERFORMANCE ROUTING ENGINE
CONSOLE
STATUS
ACO
CRITICAL
MINOR
MAJOR
ETHERNET
LINK
ACTIVITY
AUX
SLOT 0
SLOT 1
POWER
FAULT