Specifications

ManualsBrandsCisco ManualsComputer equipmentuBR10012 Universal Broadband Router UBR10-FAN-CAB=

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

Removing and Replacing an AC PEM

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

78-13996-01 Rev. B0

Figure 4 Location of DC Power Connectors and DC Power Cables

Note For more information on these DC terminal blocks, see either the Cisco uBR10012 Universal

Broadband Router Hardware Installation Guide or the DC Power Entry Module for the

Cisco uBR10012 Universal Broadband Router document, which are available on Cisco.com or the

Customer Documentation CD-ROM.

Replacing a Redundant AC PEM

Follow this procedure to replace a redundant AC PEM, which is typically needed when the Fault LED

is on and the troubleshooting steps in the “Troubleshooting the PEM” section on page 22 do not correct

the problem.

56466

ALARMS

CISCO

10000

FAIL

PERFORMANCE ROUTING ENGINE

CONSOLE

STATUS

ACO

CRITICAL

MINOR

MAJOR

ETHERNET

LINK

ACTIVITY

AUX

SLOT 0

SLOT 1