User guide
Configuring the Cisco VCS
Enable FindMe™
1. Go to the FindMe configuration page (Applications > FindMe > Configuration).
2. Configure the fields as follows:
FindMe mode On
3. Configure the fields as follows:
Caller ID
FindMe ID: the caller ID of a call being made through this Cisco VCS is
replaced with the relevant FindMe ID.
Note: For more details on the use of Caller ID and FindMe ID, see “Appendix 6 – Determining the
FindMe ID for a caller” on page 27.
4. Click Save.
Enable device authentication (recommended)
If device authentication is to be used – verifying that endpoints can identify themselves with a
username and password known to the Cisco VCS – it should be enabled now so that when users are
created the appropriate prompts are given to set up the user’s endpoint authentication credentials.
1. Go to the Device authentication configuration page (VCS Configuration > Authentication >
Devices > Configuration) and click New.
2. Configure the fields as follows:
Mode On
Database type LocalDatabase
3. Click Save.
Cisco VCS Deployment Guide: Cisco VCS Expressway Starter Pack (X5.1) Page 8 of 28