User guide

Configuring the Cisco VCS
See “Create authentication credentials for the user (optional)” below for
more details.
** The password entries are only displayed if User authentication source is set to Local (see
“Enable FindMe™“ on page 8.)
3. Click Sav
e.
4. Repeat these steps to create accounts for all users.
Additional users can be added later, as and when required, by returning to the User accounts page
and selecting New.
Note: Cisco VCS Expressway Starter Pack supports a maximum of 50 registered users.
After an account has been set up, its details (except the Username) can be edited by selecting the
user on the User accounts page (Maintenance > Login accounts > User accounts) and then
clicking View/Edit.
Create authentication credentials for the user (optional)
If device authentication has been enabled, the credentials entered into the Cisco VCS must exactly
match those used to sign on to Movi – otherwise provisioning requests, registration requests, call
requests and phone book requests will be rejected.
In a typical installation you are recommended to use the same password for both the user’s Movi
authentication credentials and for their user account login (where users access their FindMe details).
1. From near the bottom of the Create user account or Edit user account pages right-click on the
Add/Edit local authentication database
link and select ‘Open in New Window’ (or equivalent
depending on your browser version).
Alternatively using the menu go to the Local authentication database page (VCS Configuration
> Authentication > Devices > Local database).
2. Click New.
3. Configure the fields as follows:
Name
The credential name must be the same as the user account username – as
indicated by the link on the Create user account and Edit user account pages.
It is also the Movi sign in username.
Password
The password must be the same as the Movi sign in password.
(Typically this is also the same as the user account password used for accessing
FindMe details.)
4. Click Create credential.
5. If appropriate, close any new window or tab that was opened to create this credential.
Cisco VCS Deployment Guide: Cisco VCS Expressway Starter Pack (X5.1) Page 11 of 28