Specifications

Installing the Cisco TS MSE 8710
7
Figure 3: Closing the retaining latches on the front of a blade
Step two: Allocate port licences
Port licenses must be allocated to the Cisco TS MSE 8710 from the Supervisor's Port
licenses
page. Refer to the online help for assistance.
Step three: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a
hub, to minimize interference from other devices on the network). The Ethernet
port is a 10/100/1000 Mbps auto-sensing connection.
Ethernet Ports B, C and D may not be supported in the software supplied
with your blade. Do not connect to these ports unless the web interface
allows you to configure them. Do not connect multiple ports to the same
subnet unless instructed to do so by the web interface.
i