Datasheet

Data Sheet
© 2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 5 of 8
●
Feature ring with DND set
●
IP phone display of DND state
●
Dial-plan pattern load on SIP phones
●
Diversion of calls directly to voicemail
●
Customization of softkeys
●
Enable and disable call-waiting notification per line
●
Call waiting with overlay directory number
●
Call-waiting ring
●
Dual or eight call line appearances per button
●
After-hours toll-bar override
●
Auto-answer with headset
●
European date formats
●
Hook flash passthrough across analog PSTN trunks
●
Idle URL: Periodically push messages or graphics on IP phones
●
Last-number redial
●
Live record to Cisco Unity
®
Express mailbox
●
Local name directory lookup
●
On-hook dialing
●
Station speed dial with configuration changes from IP phone
●
System speed dial for 10,000 numbers
●
Silent and feature ring options
●
SIP-based line-side subscribe, providing basic presence of phone status
●
Transfer to voicemail softkey
●
Call barge with privacy on shared lines
●
Access features using softkeys or feature access codes
●
Remote teleworker IP phone support
●
Dynamic hunt-group join or leave
●
Support for analog phones using Cisco ATA 186 Analog Telephone Adaptor or Cisco VG224 Analog Voice
Gateway in SCCP mode
●
Support for fax machines on foreign-exchange-station (FXS) ports or ATA using H.323, SCCP, or SIP
●
Support for Cisco VG202 and VG204 Analog Voice Gateways
●
XML application services on Cisco Unified IP display phones
●
Station-to-station video with voice using Cisco Unified Video Advantage or Cisco Unified IP Phone 7985G
endpoints
●
Extension mobility within the single site
●
Wideband audio (G.722) and Internet low bit rate codec (iLBC)
●
Single number reach for mobility in Cisco IOS Software
●
Whisper intercom
●
Shared line on SIP phones with privacy and barge-in capabilities
Trunk features
●
Analog foreign-exchange-office (FXO) Loop and Ground Start
●
Ear and mouth (E&M)
●
Basic Rate Interface (BRI) and Primary Rate Interface (PRI) support (NI2, 4ESS, 5ESS, EuroISDN, DMS100,
and DMS250) and several other switch types currently supported in Cisco IOS Software
●
Caller ID name and number
●
Automatic number identification (ANI)
●
Digital trunk support (T1/E1)
●
Direct inward dialing (DID)
●
Direct outward dialing
●
E1 R2 support
●
Dedicated trunk mapping to phone button
●
H.323 trunks with H.450 support
●
H450.12 automatic detection of H.450 support for remote H.323 endpoints
●
H.323-to-H.323 hairpin call routing for non-H.450-compliant H.323 endpoints
●
SIP trunks and RFC 2833 support
●
Transcoding with G.711, G.729a, and iLBC
●
ECMA/ISO ISDN Q.SIG supplementary services of basic calls, including:
●
Call forwarding busy, no answer, all
●
Calling line identification presentation (CLIP) and calling name identification presentation (CNIP)
●
Connected line identification presentation (COLP) and connected name identification presentation (CONP)
●
Message waiting indicator (MWI) and message center support
●
MWI passthrough QSIG-to-time-division multiplexing (TDM) voicemail