Datasheet

Configuring the Network
QoS
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 74
5
CoS To Queue
Use the CoS To Queue page to queue traffic based on Ethernet Class of Service
(CoS) settings.
STEP 1 Click Network Setup > QoS > CoS To Queue. The CoS To Queue window opens.
STEP 2 Change the priority settings for each VLAN CoS as necessary.
The VLAN (CoS) priority tag (0-7) values are mapped to router’s queue, where zero
is the lowest and 7 is the highest.
STEP 3 Choose a priority level from the drop-down list.
The priority defines the traffic forwarding queue to which traffic
the given CoS is
mapped.
Click Submit to save your settings.
VLAN Category
Name Enter the name of the Ethernet port. For example: data_Lan.
VLAN Choose the source VLAN.
IP Address
Name Enter a name to describe this rule.
Destination IP Enter the target IP address or network that will classify the
traffic for this rule.
Destination
Mask
Enter the mask for the target IP address or network.
LAN Choose the source LAN.
QoS Policy Settings: Queuing
Priority Choose the queuing priority for this traffic: Strict, High,
Medium, Normal, or Low.