Datasheet

Configuring the Network

QoS

Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 71

QoS

This section describes how to configure Quality of Service (QoS) settings for the

SRP. It includes the following sections:

• QoS Bandwidth Control

• QoS Policy

• CoS To Queue

• DSCP To Queue

To access these pages click Network Setup > QoS from the Configuration Utility.

QoS Bandwidth Control

Use the QoS Bandwidth Control page to allow the SRP to rate limit upstream data

transmissions to suit the broadband service.

STEP 1 Click Network Setup > QoS > Bandwidth Control. The QoS Bandwidth Control

window opens.

STEP 2 Click Enabled next to the interface on which you want to enable bandwidth

control. Uncheck the box to disable it. The default setting is Disabled.

STEP 3 To configure available bandwidth for each physical interface, click the Edit (pencil)

icon. The Bandwidth Shaping Control window opens.

STEP 4 Specify the bandwidth shaping control values as defined in the Bandwidth

Shaping Control Settings table.

STEP 5 Click Submit to save your settings.