Datasheet

Setting up the Interfaces of the Services Ready Platforms
Using the Management Interface
Cisco SRP500 Series Services Ready Platforms Administration Guide (SRP520 Models) 61
4
WMM Setting
Use the WMM Setting page to configure support for Wi-Fi Multimedia (WMM)
devices on your network.
STEP 1 Click Interface Setup > Wi-Fi Settings > WMM Setting. The WMM Setting
window opens.
STEP 2 If you have other devices on your network that support WMM, keep the default
setting Enabled.
STEP 3 In the No Acknowledgement option, select Enabled to disable the
acknowledgement feature, so that the SRP will not resend data if an error occurs.
The default is Disabled.
STEP 4 Click Submit to save your settings.
Using the Management Interface
Use the Management Interface page to set the Loopback Interfaces, which can be
used for routing updates and some protocols. You can set up to two loopback
interfaces.
STEP 1 Click Interface Setup > Management Interface. The Management Interface
window opens.
STEP 2 To edit an entry in the List of Loopback Interfaces, click the Edit (pencil) icon.
The Manually Adding Loopback window opens.
STEP 3 Enter the IP Address to use for the loopback interface. The address must not
overlap with any other interface configured on the SRP.
NOTE The IP Address used for the loopback interface assumes a subnet mask of
255.255.255.255.
STEP 4 Click Submit to save your settings.