User guide
!
"#$%!&'()$!*+%!,(#-+!./0&1!./2&!34)!./5&!! ! ! !
:0!
Caring
for Your
Phone
The
Cisco
Small
Bus
i
ne
ss
Pro IP
phones are electronic devices
that
should
not
b
e
exposed
to
excessive
heat
,
sun, cold or
wat
e
r
.
To
clean
the
e
q
uipment
,
use a
slightly
moistened paper
or cloth
towel. Do not
spray
or
pour cleaning
s
o
lution
directly
onto the
hardware
unit
.
Before
You
Be
g
i
n
The
RJ-11 port marked
“AUX”
is
reserved
for
connection
with the
Cisco
SPA
500S
Attendant
NOTE
Console
that
works
with the IP
phone
s
.
It
is not for
use as
a
telephone line
po
r
t
.
!
CAUTION: Do not plug a
telephone
line
cord
into the
port marked
“
A
UX
.”
CAUTION
Phone
C
o
nne
c
tions
The
following photo shows where
you
need
to
connect parts
of the
phone.
F
i
gur
e
1
Phone
C
o
nn
e
c
tion
s
Verifying Phone Startup
After receiving power and network connectivity, the phone executes a boot-up sequence. During this sequence,
phones with screens display the Cisco logo and then “Initializing Network”. All of the lights on the phone will flash.
After your phone is successfully connected to the network and receives a basic configuration, your phone line keys
should glow green (on models with phone line keys).
On models with screens, the phone displays the standard menu for the phone. The date, name and number of the
phone display on the top line of the LCD screen. At the bottom of the LCD screen, softkeys are displayed over their
associated soft buttons.
On models with no screen, such as the Cisco SPA 501G, the lines should glow green and you should hear a dial tone
when picking up the handset or pressing the speakerphone button.
If the phone does not start, confirm your installation and connections. If these are correct, try unplugging the phone
and plugging it back in again. If you still donʼt see the display, then contact your IT support personnel or call
Megagate Broadband support for more assistance.