User guide
Table Of Contents
- Getting Started
- Phone Components
- Softkey Buttons
- Using Keypad Shortcuts
- Installing Your Phone
- Reversing the Handset Retention Tab
- Connecting the Phone to the Wireless Network
- Determining Your Current Firmware Version
- Download the Firmware
- Get Your Phone’s IP Address
- Install the Firmware
- Using Basic Phone Functions
- Using the Speakerphone
- Using the Headset with Your IP Phone
- Switching Between the Handset/Headset/Speakerphone During a Call
- Sending Audio to the Phone Speaker
- Choosing Your Preferred Audio Device
- Adjusting Call Volume
- Adjusting the Ringer Volume
- Using Mute
- Using Dial Assistance
- Performing an Attended Transfer
- Performing an Unattended (Blind) Transfer
- Performing an Transfer to Voicemail
- Transferring a Held Call to an Active Call
- Forwarding All Calls
- Forwarding Calls When Your Phone is Busy
- Forwarding Calls When You Don’t Answer the Phone
- Delaying Call Forwarding When You Don’t Answer the Phone
- Stopping Call Forwarding
- Activating Do Not Disturb
- Deactivating Do Not Disturb
- Conferencing a Held Call with an Active Call
- Conference Menu Options
- Using Your Personal Directory
- Using the Corporate Directory
- Viewing the Call History Lists
- Calling from the Call History Lists
- Deleting a Number from the Call History Lists
- Saving a Call History List Number to Your Directory
- Using Advanced Phone Features
- Creating Speed Dials on Unused Line Buttons
- Creating Numerical Speed Dials
- Changing the LCD Screen Contrast
- Changing the Screen Backlight Settings
- Configuring the Phone Screen Saver
- Turning on the Screen Saver
- Changing Your Ring Tone
- Setting Your Phone’s Date and Time
- Rebooting Your Phone
- Using the Web Interface
- Where to Go From Here
Installing Your Phone
Connecting the Handset
Cisco Small Business Pro IP Phone SPA 504G User Guide (SIP) 11
2
Connecting the Handset
STEP 1 Turn the phone body over to expose the ports on the back of the unit.
!
CAUTION Do not insert a telephone line cord into the auxiliary port.
STEP 2 Insert the long end of the phone cord into the handset port on the phone body that is marked
with a phone symbol.
STEP 3 (Optional) Route the phone cord through the cable slot.
STEP 4 Insert the other end of the phone cord into the port at the bottom of the handset (not shown).
Installing the Stand (Optional)
NOTE Do not attach the desk stand if you want to mount the phone to the wall. If you are attaching a
Cisco SPA 500S attendant console, attach the console before attaching the desk stand.
STEP 1 Connect the phone stand by lining up the tabs on the stand with the slots on the phone body.
STEP 2 Slide the bottom tabs into the lower slots on the phone body and lightly press down on the
stand. It should easily slide into the upper stand slots. Do not force.