User guide
Table Of Contents
- Getting Started
- Phone Components
- Softkey Buttons
- Using Keypad Shortcuts
- Installing Your Phone
- Reversing the Handset Retention Tab
- Connecting the Phone to the Wireless Network
- Determining Your Current Firmware Version
- Download the Firmware
- Get Your Phone’s IP Address
- Install the Firmware
- Using Basic Phone Functions
- Using the Speakerphone
- Using the Headset with Your IP Phone
- Switching Between the Handset/Headset/Speakerphone During a Call
- Sending Audio to the Phone Speaker
- Choosing Your Preferred Audio Device
- Adjusting Call Volume
- Adjusting the Ringer Volume
- Using Mute
- Using Dial Assistance
- Performing an Attended Transfer
- Performing an Unattended (Blind) Transfer
- Performing an Transfer to Voicemail
- Transferring a Held Call to an Active Call
- Forwarding All Calls
- Forwarding Calls When Your Phone is Busy
- Forwarding Calls When You Don’t Answer the Phone
- Delaying Call Forwarding When You Don’t Answer the Phone
- Stopping Call Forwarding
- Activating Do Not Disturb
- Deactivating Do Not Disturb
- Conferencing a Held Call with an Active Call
- Conference Menu Options
- Using Your Personal Directory
- Using the Corporate Directory
- Viewing the Call History Lists
- Calling from the Call History Lists
- Deleting a Number from the Call History Lists
- Saving a Call History List Number to Your Directory
- Using Advanced Phone Features
- Creating Speed Dials on Unused Line Buttons
- Creating Numerical Speed Dials
- Changing the LCD Screen Contrast
- Changing the Screen Backlight Settings
- Configuring the Phone Screen Saver
- Turning on the Screen Saver
- Changing Your Ring Tone
- Setting Your Phone’s Date and Time
- Rebooting Your Phone
- Using the Web Interface
- Where to Go From Here
Installing Your Phone
Before You Begin
Cisco Small Business Pro IP Phone SPA 504G User Guide (SIP) 10
2
Before You Begin
Before you install and connect your phone, verify with your System Administrator (if
applicable) that the network is ready for the phone, read the safety notices, and make sure you
have all the phone parts and documentation available.
NOTE The RJ-11 port marked “AUX” is reserved for connection with the Cisco SPA 500S Attendant
Console that works with the IP phones. It is not for use as a telephone line port.
!
CAUTION CAUTION: Do not plug a telephone line cord into the port marked “AUX.”
Phone Connections
The following photo shows where you need to connect parts of the phone.
Figure 1 Phone Connections