System information

Configuring the Voice Settings
Regional
Cisco SPA232D Administration Guide 90
4
Vertical Service Activation Codes
Vertical Service Activation Codes are automatically appended to the dial-plan.
There is no need to include them in dial-plan, although no harm is done if they are
inclu`ded.
CPC Delay Delay in seconds after caller hangs up when the ATA
starts removing the tip-and-ring voltage to the attached
equipment of the called party. The range is 0–255
seconds. This feature is generally used for answer
supervision on the caller side to signal to the attached
equipment when the call has been connected (remote end
has answered) or disconnected (remote end has hung up)
This feature should be disabled for the called party (in
other words, by using the same polarity for connected and
idle state) and the CPC feature should be used instead.
Without CPC enabled, reorder tone will is played after a
configurable delay. If CPC is enabled, dial tone will be
played when tip-to-ring voltage is restored. Resolution is 1
second.
Default setting: 2
CPC Duration Duration in seconds for which the tip-to-ring voltage is
removed after the caller hangs up. After that, tip-to-ring
voltage is restored and the dial tone applies if the
attached equipment is still off-hook. CPC is disabled if this
value is set to 0. Range: 0 to 1.000 second. Resolution is
0.001 second.
Default setting: 0 (CPC disabled)
Field Description
Call Return Code Call Return Code This code calls the last caller.
Default setting: *69
Call Redial Code Redials the last number called.
Default setting: *07
Blind Transfer
Code
Begins a blind transfer of the current call to the extension
specified after the activation code.
Default setting: *98
Field Description