System information

Configuring the Voice Settings

Provisioning

Cisco SPA232D Administration Guide 79

Firmware Upgrade

Report Rule The target URL to which configuration reports are sent.

This parameter has the same syntax as the Profile_Rule

parameter, and resolves to a TCP/IP command with an

associated URL.

A configuration report is generated in response to an

authenticated SIP NOTIFY message, with Event: report.

The report is an XML file containing the name and value of

all the device parameters.

This parameter may optionally contain an encryption key.

For example:

[ --key $K ] tftp://ps.callhome.net/$MA/rep.xml.enc

Default setting: blank

Field Description

Upgrade Enable Determines whether or not firmware upgrade operations

can occur independently of resync actions.

Default setting: yes

Upgrade Error

Retry Delay

The upgrade retry interval (in seconds) applied in case of

upgrade failure. The ATA has a firmware upgrade error

timer that activates after a failed firmware upgrade

attempt. The timer is initialized with the value in this

parameter. The next firmware upgrade attempt occurs

when this timer counts down to zero.

Default setting: 3600 seconds

Downgrade Rev

Limit

Enforces a lower limit on the acceptable version number

during a firmware upgrade or downgrade. The ATA does

not complete a firmware upgrade operation unless the

firmware version is greater than or equal to this parameter.

Default setting: blank

Upgrade Rule This parameter is a firmware upgrade script with the

same syntax as Profile_Rule. Defines upgrade conditions

and associated firmware URLs.

Default setting: blank

Field Description