System information

Configuring the Voice Settings
Provisioning
Cisco SPA232D Administration Guide 77
4
Resync Error Retry
Delay
Resync retry interval (in seconds) applied in case of
resync failure.
The ATA has an error retry timer that activates if the
previous attempt to sync with the provisioning server fails.
The ATA waits to contact the server again until the timer
counts down to zero.
This parameter is the value that is initially loaded into the
error retry timer. If this parameter is set to zero, the ATA
immediately retries to sync with the provisioning server
following a failed attempt.
Default setting: 3600 seconds
Forced Resync
Delay
Maximum delay (in seconds) that the ATA waits before
performing a resync.
The ATA does not resync while one of its lines is active.
Because a resync can take several seconds, it is desirable
to wait until the ATA has been idle for an extended period
before resynchronizing. This allows a user to make calls in
succession without interruption.
The ATA has a timer that begins counting down when all of
its lines become idle. This parameter is the initial value of
the counter. Resync events are delayed until this counter
decrements to zero.
Default setting: 14400 seconds
Resync From SIP Enables a resync to be triggered via a SIP NOTIFY
message.
Default setting: yes
Resync After
Upgrade Attempt
Triggers a resync after every firmware upgrade attempt.
Default setting: yes
Resync Trigger 1
Resync Trigger 2
Configurable resync trigger conditions. A resync is
triggered when the logic equation in these parameters
evaluates to TRUE.
Default setting: blank
Field Description