System information

Configuring the Voice Settings
Line1 Settings (PHONE Port)
Cisco SPA232D Administration Guide 117
4
Gateway Accounts
VoIP Fallback to PSTN section
FXS Port Polarity Configuration
Field Description
Gateway1/2/3/4 The first of 4 gateways that can be specified to be used in
the <Dial Plan> to facilitate call routing specification (that
overrides the given proxy information). This gateway is
represented by gw1 in the <Dial Plan>. For example, the
rule 1408xxxxxxx<:@gw1> can be added to the dial plan
such that when the user dials 1408+7digits, the call will be
routed to Gateway 1. Without the <:@gw1> syntax, all calls
are routed to the given proxy by default (except IP dialing).
Default setting: blank
GW1/2/3/4 NAT
Mapping Enable
If enabled, the ATA uses NAT mapping when contacting
Gateway 1.
Default setting: no
GW1/2/3/4 Auth ID This value is the authentication user-id to be used by the
ATA to authenticate itself to Gateway 1.
Default setting: blank
GW1/2/3/4
Password
This value is the password to be used by the ATA to
authenticate itself to Gateway 1.
Default setting: blank
Field Description
Auto PSTN
Fallback
If enabled, the ATA automatically routes all calls to the
PSTN gateway when the Line 1 proxy is down
(registration failure or network link down).
Default setting: yes
Field Description
Idle Polarity Polarity before a call is connected: Forward or Reverse.
Default setting: Forward