Technical information





Basic PPP0E set-up on IAD for ADSL modem without NAT (Network Address Translation)

To perform basic PPP0E conﬁguration on Linksys SPA2102-R3 IAD:

1. Using an Ethernet RJ45 Cable, connect your PC to the Linksys SPA2102-R3 IAD Ethernet Port.

2. Start a Web browser such as Microsoft® Internet Explorer or Netscape Navigator®.

3. GotoSTART->RUN,keyin“cmd”.Thecommandpromptwindowwillpopup

Atthecommandpromptkeyin“IPCONFIG”.YouwillbeabletoseetheDefaultGatewayIPaddress.

UsingtheDefaultGatewayIPaddress“192.168.1.1”,copytheIPaddressandpasteitatyourInternetbrowser

and it will enable you to launch the customize webpage as shown in the screen capture below.

*NotethedefaultIPaddresswillbe“192.168.0.1”.