Specifications

4-5
Linksys SPA Provisioning Guide
Version 3.01
Chapter 4 Provisioning Field Reference
Firmware Upgrade Parameters
Firmware Upgrade Parameters
The following table defines the function and usage of each parameter in the Firmware Upgrade section
of the Provisioning tab.
Table 4-2 Firmware Upgrade Parameters
Parameter Name Description and Default Value
Upgrade_Enable Enables firmware upgrade operations
independently of resync actions.
The default is Yes.
Upgrade_Error_Retry_Delay The upgrade retry interval (in seconds) applied in
case of upgrade failure. The device has a
firmware upgrade error timer that activates after
a failed firmware upgrade attempt. The timer is
initialized with the value in this parameter. The
next firmware upgrade attempt occurs when this
timer counts down to zero.
The default is 3600 seconds.
Downgrade_Rev_Limit Enforces a lower limit on the acceptable version
number during a firmware upgrade or
downgrade. The device does not complete a
firmware upgrade operation unless the firmware
version is greater than or equal to this parameter.
The default is (empty).
Upgrade_Rule This parameter is a firmware upgrade script with
the same syntax as Profile_Rule. Defines
upgrade conditions and associated firmware
URLs.
The default is (empty).
Log_Upgrade_Request_Msg Syslog message issued at the start of a firmware
upgrade attempt.
The default is $PN $MAC -- Requesting upgrade
$SCHEME://$SERVIP:$PORT$PATH.
Log_Upgrade_Success_Msg Syslog message issued after a firmware upgrade
attempt completes successfully.
The default is $PN $MAC -- Successful upgrade
$SCHEME://$SERVIP:$PORT$PATH -- $ERR.
Log_Upgrade_Failure_Msg Syslog message issued after a failed firmware
upgrade attempt.
The default is $PN $MAC -- Upgrade failed:
$ERR.
License Keys This field is empty.