User guide

Using the Phone Web User Interface
Setting Voice User Parameters
Cisco Small Business SPA50X and SPA51X Series SPCP IP Phone User Guide 57
5
Setting Voice User Parameters
The voice User parameters control the phone user options, such as caller ID and
speed dial numbers.
The table identifies and describes the parameters in the User tab.
Parameter Description
Cfwd Setting Choose yes to enable call forwarding. Choose no to disable
the feature.
Cfwd All Dest Enter the target phone number to where all calls are
forwarded. When this field is anything other than blank, the
phone rings once and the call is forwarded.
CFWD Busy Dest Enter the target phone number to where all calls are
forwarded when this phone is busy.
CFWD No Ans
Dest
Enter the target phone number to where all calls are
forwarded.
CFWD No Ans
Delay
Enter the number of seconds to delay before forwarding
calls because there is no answer at your phone.
Speed Dial X Enter the target a phone number, IP address, or URL that
will be called or launched when you press the speed dial
number. You can configure up to eight speed dials, one for
each of the numbered keys 2 through 9.
CW Setting Choose yes to enable call waiting. Choose no to disable
the feature. Call waiting alerts you when you are on a call by
ringing the phone and displaying a status message that you
have an incoming call. If you turn call waiting off, incoming
calls do not ring your phone when you are on another call,
and the caller hears a busy signal or message.
Block CID
Setting
Choose yes to block your caller ID from displaying on
another phone. Choose no to disable the feature.