User guide

Using the Phone Web User Interface
Setting Voice Regional Parameters
Cisco Small Business SPA50X and SPA51X Series SPCP IP Phone User Guide 51
5
Setting Voice Regional Parameters
This section describes the fields for the Regional tab.
Call Progress Tones
Parameter Description
Dial Tone Prompts the user to enter a phone number.
Defaults to 350@-19,440@-19;10(*/0/1+2).
Outside Dial Tone Alternative to the Dial Tone. It prompts the user to
enter an external phone number, as opposed to an
internal extension. It is triggered by a, (comma)
character encountered in the dial plan.
Defaults to 420@-16;10(*/0/1).
Prompt Tone Prompts the user to enter a call forwarding phone
number.
Defaults to 520@-19,620@-19;10(*/0/1+2).
Busy Tone Played when a 486 RSC is received for an
outbound call.
Defaults to 480@-19,620@-19;10(.5/.5/1+2).
Reorder Tone Played when an outbound call has failed or after
the far end hangs up during an established call.
Reorder Tone is played automatically when <Dial
Tone> or any of its alternatives times out.
Defaults to 480@-19,620@-19;10(.25/.25/1+2).
Off Hook Warning Tone Played when the caller has not properly placed
the handset on the cradle. Off Hook Warning Tone
is played when Reorder Tone times out.
Defaults to 480@10,620@0;10(.125/.125/1+2).
Ring Back Tone Played during an outbound call when the far end
is ringing.
Defaults to 440@-19,480@-19;*(2/4/1+2).
Call Waiting Tone Played when a call is waiting.
Defaults to 440@-10;30(.3/9.7/1)