Specifications

2-6
Cisco ONS 15454 SONET/SDH Unified Control Plane Configuration Guide
OL-4214-01
Chapter 2 User Control Plane Configuration
2.5Change an IPCC Configuration
2.5 Change an IPCC Configuration
The UCP > IPCC tab lists the existing IPCCs. Use the following procedure to change an IPCC
configuration.
Step 1 At node view, click the Provisioning > UCP > IPCC tabs.
Step 2 On the IPCC subtab, edit the following fields as necessary:
• Local IPCC
• LMP Hello Integer
• LMP Hello Dead Integer
• MTU
• CRC Mode
Step 3 Click Apply.
2.6 Change a UCP Interface Configuration
The UCP > Interface tab lists the existing interfaces. Use the following procedure to change an interface
configuration.
Note If a circuit exists, you cannot edit the Interface fields.
Step 1 At node view, click the Provisioning > UCP > Interface tabs.
Step 2 On the Interface subtab, edit the following fields as necessary:
• TNA Type
• TNA Address
• Core ID
Step 3 Click Apply.
2.7 Delete a Neighbor, IPCC, Interface, or UCP-Signaled Circuit
The Neighbor, IPCC, Interface, and Circuit subtabs all include Delete buttons. You must delete in the
following order:
• If a neighbor has an associated IPCC, you must delete the IPCC before CTC allows you to delete
the neighbor.
• If an IPCC has an associated interface, you must delete the interface before CTC allows you to delete
the IPCC.