Specifications

2-2
Cisco ONS 15454 SONET/SDH Unified Control Plane Configuration Guide
OL-4214-01
Chapter 2 User Control Plane Configuration
2.1Configure an ONS 15454 as User Network Interface–Client (UNI-C) Node
Figure 2-1 UCP Tab
Step 3
On the Node tab, verify the node-level UCP parameters, and edit as necessary:
• UCP Node ID—Node IP address
• Initial Interval—Initial retry interval for circuits released by the network (60 to 1800 seconds)
• Max. Interval—Maximum retry interval (180 to 1800 seconds; must be greater than the Circuit Retry
Initial Interval)
• Restart Time—Time required for the node to restart (60 to 300 seconds); signaled to neighbors
• Re-transmit Interval—Interval for retransmitting unacknowledged messages (1 to 7 seconds)
• Recovery Time—Time required by the node to resynchronize the path and reservation states with a
neighbor (300 to 1800 seconds); signaled to neighbors
• Refresh Interval—Interval for refreshing path and reservation states (30 to 4660800 seconds)
• RESV—Timeout interval while waiting for the reservation request (RESV) message (10 to 180
seconds; a connection is established when the initiating node receives a RESV message for the
connection
• RESV CONF—Timeout interval while waiting for the reservation confirmation (RESV CONF)
message (10 to 180 seconds; the RESV CONF acknowledges receipt of the RESV message
• Source Deletion in Progress—Timeout interval while the source node is cleanly deleting a call (10
to 180 seconds)
• Destination Deletion in Progress—Timeout interval while the destination node is cleanly deleting a
call (10 to 180 seconds)
Step 4 Click the UCP Provisioning button to start the Provision UCP wizard.
Step 5 On the Existing Neighbors list, choose the neighbor for which you want to set up the IP control channel
(IPCC) and continue with Step 6. To create a neighbor, click Create on the Unified Control Plane
Provisioning dialog box. In the Create a New Neighbor dialog box, complete the following fields and
click OK:
• Neighbor Name—Type a neighbor name in the field (a maximum of 64 alphanumeric characters).
• Neighbor Discovery—To enable automatic neighbor discovery, check the check box. If you do not
check the Neighbor Discovery check box, type the IP address of the neighbor in the Node ID field.
• Hello—To enable RSVP hello, check the check box and choose the hello interval from the
drop-down list.