Specifications

5
Installing Cisco ONS 15454 SONET/SDH OPT-BST Cards
78-16594-02
OPT-BST Card Specifications
• COM Rx is the input signal port.
• LINE Tx is the output signal port.
• LINE Rx is the input signal port (receive section).
• COM Tx is the output signal port (receive section).
• OSC Rx is the OSC add input port.
• OSC Tx is the OSC drop output port.
OPT-BST Card Specifications
The OPT-BST card has the following specifications:
• Optical characteristics:
– Total operating wavelength range: 1530 to 1561.3 nm
– Gain ripple (peak to valley): 1.5 dB
– Gain range: 5 to 20 dBm with programmable gain tilt
– Gain and power regulation over/undershoot: 0.5 dB
– Limited maximum output power: 17.5 dBm
– Maximum output power (with full channel load): 17 dB
– Minimum output power (with one channel): -1 dBm
– Input power (Pin) range at full channel load: -3 to 12 dBm
– Input power (Pin) range at single channel load: -21 to -6 dBm
– Noise figure at G3 20 dB = 6 dB
– OSC filter drop (channels) insertion loss maximum: 1 dB
– OSC filter drop (OSC) insertion loss maximum: 1.8 dB
– OSC filter add (OSC) insertion loss maximum: 1.3 dB
– Optical connectors: LC-UPC/2 Transmitter OSC signal
• Environmental
– Operating temperature:
C-Temp: -5 to +55 degrees Celsius (+23 to +131 degrees Fahrenheit)
– Operating humidity: 5 to 85%, noncondensing
• Dimensions
– Height: 12.65 in. (321.3 mm)
– Width: 0.92 in. (23.4 mm)
– Depth: 9.00 in. (228.6 mm)
• For compliance information, refer to the Cisco Optical Transport Products Safety and Compliance
Information.