System information

Configuring Security
Access Profiles
Cisco Small Business 300 Series Managed Switch Administration Guide 204
16
- SNMP—Users requesting access to the switch who meet the SNMP
access profile criteria are permitted or denied.
• Action—Select the action attached to the rule. The options are:
- Permit—Permits access to the switch if the user matches the settings in
the profile.
- Deny—Denies access to the switch if the user matches the settings in the
profile.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies only to the port, VLAN, or LAG selected.
• Applies to Source IP Address—Select the type of source IP address to
which the access profile applies. The Source IP Address field is valid for a
subnetwork. Select one of the following values:
- All—Applies to all types of IP addresses.
- User Defined—Applies to only those types of IP addresses defined in
the fields.
• IP Version—Select the supported IP version of the source address, IPv6 or
IPv4.
• IP Address—Enter the source IP address.
• Mask—Select the format for the subnet mask for the source IP address, and
enter a value in one of the fields:
- Network Mask—Select the subnet to which the source IP address
belongs and enter the subnet mask in dotted decimal format.
- Prefix Length—Select the Prefix Length and enter the number of bits
that comprise the source IP address prefix.
STEP 6 Click Apply. The access profile is created, and the switch is updated. You can now
select this access profile as the active access profile.