System information
Configuring Security
Configuring TCP/UDP Services
Cisco Small Business 200 Series Smart Switch Administration Guide 173
16
STEP 5 Click Apply, and the rule is added to the access profile.
Configuring TCP/UDP Services
The
TCP/UDP Services Page
enables TCP or UDP-based services on the switch,
usually for security reasons.
The switch offers HTTP TCP/UDP services.
To view these services:
STEP 1 Click Security > TCP/UDP Services. The TCP/UDP Services Page displays.
The TCP Services table displays the following information:
• HTTP Service—Indicates whether HTTP service is enabled or disabled.
• Service Name—Management access method through which the switch is
offering the service.
• Type—IP protocol the service uses.
• Local IP Address—Local IP address through which the switch is offering the
service.
• Local Port—Local TCP port through which the switch is offering the service.
• Remote IP Address—IP address of the remote device that is requesting the
service.
• Remote Port—TCP port of the remote device that is requesting the service.
• State—Status of the service.
The UDP Services table displays the following information:
• Service Name—Management access method through which the switch is
offering the service.
• Type—IP protocol the service uses.
• Local IP Address—Local IP address through which the switch is offering the
service.
• Local Port—Local UDP port through which the switch is offering the service.