System information

Configuring Multicast Forwarding
Adding IP Multicast Group Addresses
Cisco Small Business 200 Series Smart Switch Administration Guide 132
14
Adding IP Multicast Group Addresses
The IP Multicast Group Address Page is similar to the MAC Group Address Page
except that Multicast groups are identified by IP addresses.
The
IP Multicast Group Address Page enables querying and adding IP Multicast
groups.
To define and view IP Multicast groups:
STEP 1 Click Multicast> IP Multicast Group Address. The IP Multicast Group Address
Page
opens.
The page displays all of the IP Multicast group addresses learned by snooping.
STEP 2 Enter the parameters required for filtering.
• VLAN ID equals to—Define the VLAN ID of the group to be displayed.
• IP Version equals to—Select IPv6 or IPv4.
• IP Multicast Group Address equals to—Define the IP address of the
Multicast group to be displayed. This is only relevant when Forwarding
mode is (S,G).
• Source IP Address equals to—Define the source IP address of the sending
device. If mode is (S,G), enter the sender S. This together with the IP Group
Address is the Multicast group ID (S,G) to be displayed. If mode is (*.G), enter
an * to indicate that the Multicast group is only defined by destination.
STEP 3 Click Go. The results are displayed in the lower block. When Bonjour and IGMP are
enabled, the IP Multicast address of Bonjour is displayed.
STEP 4 Click Add to add a static IP Multicast Group Address. The IP Multicast Interface
Settings Page opens.
STEP 5 Enter the parameters.
• VLAN ID—Defines the VLAN ID of the group to be added.
• IP Version—Select the IP address type.
• IP Multicast Group Address—Define the IP address of the new Multicast
group.
• Source Specific—Indicates that the entry contains a specific source, and
adds the address in the IP Source Address field. If not, the entry is added as
a (*,G) entry, an IP group address from any IP source.