System information

Configuring Multicast Forwarding

Adding MAC Group Address

Cisco Small Business 200 Series Smart Switch Administration Guide 131

• MAC Group Address Equals To—Set the MAC address of the Multicast

group to be displayed. If no MAC Group Address is specified, the page

displays all the MAC Group Addresses from the selected VLAN.

STEP 3 Click Go, and the MAC Multicast group addresses are displayed in the lower

block.

STEP 4 Click Add to add a static MAC Group Address. The

Add MAC Group Address

Page

opens.

STEP 5 Enter the parameters.

• VLAN ID—Defines the VLAN ID of the new Multicast group.

• MAC Group Address—Defines the MAC address of the new Multicast

group.

STEP 6 Click Apply, the MAC Multicast group is added, and the switch is updated.

To configure and display the registration for the interfaces within the group, select

an address, and click Details. The MAC Group Address Settings Page opens.

The page displays:

• VLAN ID—The VLAN ID of the Multicast group.

• MAC Group Address—The MAC address of the group.

STEP 7 Select the port or LAG to be displayed from the Filter: Interface Type menu.

STEP 8 Click Go to display the port or LAG membership.

STEP 9 Select the way that each interface is associated with the Multicast group:

• Static—Attaches the interface to the Multicast group as a static member.

• Forbidden—Specifies that this port is forbidden from joining this group on

this VLAN.

• None—Specifies that the port is not currently a member of this Multicast

group on this VLAN.

STEP 10 Click Apply, and the switch is updated.