User guide

4-7
Cisco H.323 Signaling Interface User Guide
OL-2156-04 Rev. A1
Chapter 4 Managing the Cisco HSI
Overload
Disk usage can trigger a LOW_DISK_SPACE alarm. For more information about this alarm, see
Chapter 5, “Troubleshooting Cisco HSI Alarms.”
Overload Level 1
Use the following configuration parameters for overload level 1 (see Chapter 3, “Provisioning the Cisco
HSI”):
• OVLDLEVEL1PERCENT
• OVLDLEVEL1FILTER
• OVLDLEVEL1THRESHLOWERCALLS
• OVLDLEVEL1THRESHUPPERCALLS
• OVLDLEVEL1THRESHLOWERCPU
• OVLDLEVEL1THRESHUPPERCPU
Overload Level 2
Use the following configuration parameters for overload level 2 (see Chapter 3, “Provisioning the Cisco
HSI”):
• OVLDLEVEL2PERCENT
• OVLDLEVEL2FILTER
• OVLDLEVEL2THRESHLOWERCALLS
• OVLDLEVEL2THRESHUPPERCALLS
• OVLDLEVEL2THRESHLOWERCPU
• OVLDLEVEL2THRESHUPPERCPU
Overload Level 3
Use the following configuration parameters for overload level 3 (see Chapter 3, “Provisioning the Cisco
HSI”):
• OVLDLEVEL3PERCENT
• OVLDLEVEL3FILTER
• OVLDLEVEL3THRESHLOWERCALLS
• OVLDLEVEL3THRESHUPPERCALLS
• OVLDLEVEL3THRESHLOWERCPU
• OVLDLEVEL3THRESHUPPERCPU
Setting Overload Data
The following MML commands set overload data:
set-overload:level1|level2|level3:cpu, lower=number, upper=number