User guide

CHAPTER

4-1

Cisco H.323 Signaling Interface User Guide

OL-2156-04 Rev. A1

Managing the Cisco HSI

Introduction

This chapter provides information about operation and management tasks for the Cisco H.323 Signaling

Interface (HSI) application. This chapter contains the following sections:

• Restarting the Cisco HSI Application, page 4-1

• Stopping Call Processing, page 4-1

• Starting Call Processing, page 4-2

• Stopping the Call Processing Application, page 4-2

• Starting the Call Processing Application, page 4-2

• Reporting the Cisco HSI Status, page 4-2

• Measurements, page 4-2

• Overload, page 4-6

• Logging, page 4-8

• Gapping, page 4-11

Restarting the Cisco HSI Application

To restart the Cisco HSI at the MML command prompt, use the restart-softw MML command. For more

information about this command, see Appendix A, “MML User Interface and Command Reference.”

To start the Cisco HSI application, see the “Starting the Cisco HSI” section on page 2-10.

Stopping Call Processing

To stop call processing, use the stp-callproc MML command. This command causes the handling of new

call requests to cease immediately, and, if no timeout period is specified, all existing calls are released

immediately. If a timeout period is specified, existing calls are released after the specified amount of

time has elapsed. For more information about the stp-callproc command, see Appendix A, “MML User

Interface and Command Reference.”