User guide

3-4
Cisco H.323 Signaling Interface User Guide
OL-2156-04 Rev. A1
Chapter 3 Provisioning the Cisco HSI
Cisco HSI Configuration
VSCB_PORT_NUMBER2 [0-65535] The second port number of the secondary PGW 2200.
Note This value of this parameter must match that of
VSCA_PORT_NUMBER2. This parameter is not used in a
standalone PGW configuration.
ClipClirSupported STRING CLI Presentation or restriction is enabled if this parameter is present and set to
anything other than "". For example, to enable CLIP/CLIR support, set this
parameter explicitly to “Enabled.”
RaiSupported STRING RAI support is enabled if this parameter is present and set to anything other than
"". For example, to enable RAI support, set this parameter to “Enabled.”
DtmfSupportedDirection STRING This is set to “both”, “tx,” or “rx”. If this parameter is not present or is set to any
value other than “both,” “tx,” or “rx,” the DTMF Relay feature is disabled.
DtmfSupportedType STRING This is set to “dtmf” or “basicString.” If this parameter is not present or set to
any other value, the DTMF Relay feature is disabled.
H225PavoSupported STRING Pavo support is enabled if this parameter is present and set to anything other than
"". For example, set it to “Enabled.”
PavoRedirScreeningInd [0-3] The value of the Pavo redirecting number screening indicator. (If this parameter
is not provisioned, the default is Q.931 zero—user provided, not screened.)
PavoRedirReason [0-15] The value of the Pavo redirecting number reason field. This parameter has no
default. If unprovisioned, the redirecting number parameter will not contain the
Reason for Redirection field (octet 3b).
PavoRedirPresInd [0-3] The value of the Pavo redirecting number presentation indicator. (If this
parameter is not provisioned, the default is Q.931 zero—no indication.)
CliInDisplaySupported STRING If this parameter is present and set to anything other than "", the Calling Number
is also sent in the DISPLAY IE. The NetMeeting endpoint retrieves the calling
party number from the DISPLAY IE in the H.225 setup message. To enable this
parameter, set it to “Enabled.”
T38MaxVal STRING
This T.38 Faxt38MaxVal parameter has the following optional attributes that can
be assigned values in a specific range.
Note Values for the following attributes must be expressed in hexadecimal
format.
• MaxBit—[0x0—0xFFFFFFFF]. The default value is 0x90.
• FxMaxBuf—[0x0—0xFFFFFFFF]. The default value is 0xc8.
• FxMaxData—[0x0—0xFFFFFFFF]. The default value is 0x48.
T38Options STRING
This T.38 Fax parameter is assigned one of the following optional values:
• FxFillBit—[0 or 1] The default value is 0.
• FxTransMMR—[0 or 1] The default value is 0.
• FxRateTransJBIG—[0 or 1] The default value is 0.
• FXRate—[Local or Trans] The default value is Trans.
• FxUdpEC—[Red or FEC] The default value is Red.
Table 3-3 Static System Data Parameters (continued)
Parameter Type Description