User guide

2-6
Cisco H.323 Signaling Interface User Guide
OL-2156-04 Rev. A1
Chapter 2 Installing and Configuring Cisco HSI Software
Installing the Cisco HSI
Enter GoldWing user name
Step 7 Type the Cisco HSI user name mgcusr and press Enter (the default user name is cisco). The following
text displays:
Enter GoldWing group name
Step 8 Type the Cisco HSI group name mgcgrp and press Enter (the default user group name is sysadmin). The
following text displays:
Enter GateKeeper IP Address
Step 9 Type the gatekeeper IP address (see Table 2-2) and press Enter. The following text displays:
Enter GateKeeper Port
Step 10 Type the gatekeeper port (see Table 2-2) and press Enter (the default port is 1719). The following text
displays:
Enter GateWay Prefix
Step 11 Type the gateway prefix (see Table 2-2) and press Enter.
Note The gateway prefix is the prefix that, when dialed from the H.323 network, causes the Cisco HSI
to route the call over E-ISUP to the PGW 2200.
The following text displays:
Enter Terminal Alias
Step 12 Type the terminal alias (see Table 2-2) and press Enter. The following text displays:
Enter GateKeeper Id
Step 13 Type the gatekeeper ID (see Table 2-2) and press Enter.
Note The gatekeeper ID must match the entry configured in the gatekeeper.
The following text displays:
Enter E-ISUP Host Port
Step 14 Type the E-ISUP host port (see Table 2-2) and press Enter.
Note The E-ISUP host port is typically 8003, but it must match the peer port setting of the IPLNK
object in the PGW 2200 configuration.
The following text displays:
Enter VSC1 Name
Step 15 Type the VSC1 name and press Enter.
Note The VSCI name is either the DNS host name (if DNS is configured) or the IP address of the
PGW 2200.