User guide

2-5

Cisco H.323 Signaling Interface User Guide

OL-2156-04 Rev. A1

Chapter 2 Installing and Configuring Cisco HSI Software

Installing the Cisco HSI

This section provides step-by-step instructions for installing a single Cisco HSI for use with a simplex

PGW 2200 configuration (a configuration with one Cisco PGW 2200 host). To install a dual Cisco HSI

for use with a redundant PGW 2200 configuration (a configuration with two Cisco PGW 2200 hosts),

complete the steps in this section and then proceed to the “Installing a Dual Cisco HSI for a Redundant

PGW 2200 Configuration” section on page 2-9.

Note In the following installation procedure, the package name is OTTgw000 and the version of the software

is 2.21; the /export/BUILDS directory is used to install the system software.

To install the Cisco HSI, complete the following steps:

Step 1 Verify that the Sun Solaris 8 operating system is installed. See the “Installing the Sun Solaris 8 Operating

System” section on page 2-1 for more information.

Step 2 Insert the Cisco HSI software CD in the CD-ROM drive.

Step 3 Log in as root and enter the following commands at the # prompt:

# cd /export/BUILDS

# tar xvf /mnt/cdrom/GoldWing-2.21.tar

The following text displays:

x ./2.21/APPLICATIONS, 0 bytes, 0 tape blocks

x ./2.21/APPLICATIONS/OTTgw000.pkg, 38954496 bytes, 76083 tape blocks

x ./2.21/install.sh, 5223 bytes, 11 tape blocks

x ./2.21/uninstall.sh, 3053 bytes, 6 tape blocks

Step 4 At the # prompt, enter the following commands:

# cd /export/BUILDS/2.21

# ./install.sh

The following text displays:

Processing package instance <OTTgw000> from

</export/BUILDS/2.21/APPLICATIONS/OTTgw000.pkg>

GoldWing H323 Adjunct Processor V0.1.6

(sparc) 2.21

This product is protected by copyright and distributed under

licenses restricting copying, distribution and decompilation.

Enter GoldWing base directory path (default /opt/GoldWing) [?,q]

Step 5 Press Enter to select the default HSI base directory path.

Caution We strongly recommend that you select the default base directory path. Operational issues

might arise if other directories are used.

The following text displays:

Enter base directory path (default /opt/GoldWing/2.21) [?,q]

Step 6 Press Enter to select the default base directory path. The following text displays: