User guide

2-4
Cisco H.323 Signaling Interface User Guide
OL-2156-04 Rev. A1
Chapter 2 Installing and Configuring Cisco HSI Software
Installing the Cisco HSI
The Cisco HSI application software is distributed in the OTTgw000.pkg file, which is in a Sun Packaging
Stream file format.
The Cisco HSI application software is distributed as a tar file with a name format GoldWing-xxxx.tar,
where xxxx is the version ID: for example, GoldWing-2.21.tar.
The default installation directory is /opt/GoldWing. You can specify a different directory. More than one
version of the software can exist. The parent directory is in /opt/GoldWing/2.21.
Links point to the current active version of the Cisco HSI application, as follows:
• currentPM points to the current version to use for all software except the call processing application.
• currentGW points to the version that may not be the latest version of the call processing application.
(GWmain)
Table 2-3 shows the subdirectories of the /opt/GoldWing/currentPM directory.
Exported provisioning files are stored in /opt/GoldWing/export.
VSC1 port
Note Typically 8003, but this entry must match the
peer port setting of the IPLNK object in the
PGW 2200 configuration.
Installation node ID
Hardware platform Sun Netra T1
Sun Netra 120
Sun Fire V120 (Default)
Installation location
1. VSC = virtual switch controller
2. DNS = domain name system
3. PGW = PSTN Gateway
Table 2-2 Cisco HSI Installation Information (continued)
Required Information Notes
Table 2-3 CurrentPM Subdirectories
Subdirectory Contents
./bin All compiled executables.
./local All scripts.
./etc Base configuration files.
./lib Shared libraries required by executables.
./toolkit Toolkit files.
./var Volatile directory that contains file locks and so on.
./var/log Default log directory.
./var/prov Provision system writes provisioning config files here.
./var/trace Trace logs are written here.